FAQ - AIP

Faq

Trouble Shooting

Installation

Operation

Test cannot be started
- If the testing can not be start, and the software shows no abnormal, please check the start mode setting.
  More
Temperature compensation setting
- For touch screen panel, enter Model-DCR setting, operator can set the temperature compensation and standard temperature for winding resistance conversion.
  More
External power supply installation
- Please note the input and output of the power supply, left blocks is for input connection, right side is for output connection.
  More
How to calibrate screen
- When the screen mouse drift occurs,
  More
Resistance compensation value setting
- For touch screen panel, operator should shift to CAPS input mode to input a negative symbol “-“.
  More
How to change test clamp?
- When it is required to replace the test clamps, please loose the screw and take the clamps set out from the table, then separate the test clamps.
  More
Method of replacing test module board
- Loosen the screws fixing the upper and lower board cards with a screwdriver.
  More
Upgrade program with USB flash drive
- Comparison of before and after USB flash drive upgrade.
  More
Intallation of light tower and LCD monitor
- The Alarm light tower are equipped with different interface such as RS232 or green terminal blocks, please connect the it properly,
  More

1 2